![]() Loaded: loaded (/etc/init.d/hostapd generated vendor preset: enabled)Īctive: active (running) since Sun 14:34:26 CEST 2min 28s ago rvice - LSB: Advanced IEEE 802.11 management daemon.└─466 /usr/sbin/hostapd -B -P /run/hostapd.pidĪgo 05 14:34:18 raspberrypi systemd: Starting LSB: AdvaĪgo 05 14:34:26 raspberrypi hostapd: Starting advanceĪgo 05 14:34:26 raspberrypi systemd: Started LSB: Advan Process: 328 ExecStart=/etc/init.d/hostapd start (code=e Loaded: loaded (/etc/init.d/hostapd generated vendorĪctive: active (running) since Sun 14:34:26 rvice - LSB: Advanced IEEE 802.11 management d I have noticed that I need to kill hostapd after boot with sudo killall hostapd ,Īnd then restart again to make it works with sudo hostapd /etc/hostapd/nfīut the auto start not, I've already added at /etc/default/hostapd DAEMON_CONF="/etc/hostapd/nf"ĮDIT: doing sudo systemctl enable $ sudo systemctl status hostapd ![]() ![]() I spend the whole day to understand how to use the Raspberry (1 B+) as access point with the awus036nha with scratch, following this guide, Setting up a Raspberry Pi as an access point in a standalone network (NAT), but can't start hostapd after boot, wpa_supplicant is disabled: sudo nano /etc/nf
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |